End Mill Discount - Carbide End Mills

Aluminum Roughing & Finishing Micro grain Carbide End Mills
	Runs 50% to 300% faster in Aluminum Longer Tool Life Faster Feed Rates Better Chip Evacuation Less Tool Deflection Leaves Superior Finishes Metric, and Specials available on request Radius and Left Hand available on request
The Swift-CARBCNC TM manufactured End Mill is a High Performance, High Helix tool, which has tighter control and tolerances on circle ground margins, double rake polished flutes, and micro finishes. Increased speeds are obtainable with Swift-CARBCNC TM allowing you to remove material up to 10 times faster. This means increased productivity and higher profits off your shop floor. The Swift-CARBCNC TM End Mill is designed for slotting, profiling, and ramping at high speeds and feeds which makes it perfect for the machining of nonferrous materials (Aluminum, Plastics, and Copper Alloys).

Swift-CARBCNC TM

Aluminum Series "SC" - High Helix - 2 & 3 Flute

Chip
Load
Chart

Dia of
End Mill

Materials: Aluminum or Plastics

Materials: Copper

2 Flute SFM 450-1200
Speed RPM	Feed IPM

3 Flute SFM 450-1200
Speed RPM	Feed IPM

2 Flute SFM 200-600
Speed RPM	Feed IPM

3 Flute SFM 200-600
Speed RPM	Feed IPM

1/8

3/16

1/4

3/8

7/16

1/2

9/16

5/8

3/4

7/8

1-1/4

The Speeds and Feeds recommended on the aluminum charts are for starting points only.

TERM	EQUATION	RESULT
Revolution Speed	RPM = 3.82 x SFPM ÷ Dia.	= Required RPM
Surface Feet per Minute	SFPM = .262 x Dia. x RPM	= Surface Feet per Minute
Inches per Minute	IPM = RPM x Inches per Tooth x No. of Teeth	= Inches per Minute in Travel
Feed per Tooth Inches per Tooth	IPT = IPM ÷ RPM ÷ No. of Flutes	= Chip Load per Tooth Per Revolution

Questions? Send a email to
or give us a call at 888-305-TOOL or send a Fax to 888-649-TOOL
End Mill Discount sells tools made in the USA.